| |
| Remote Surveillance Becomes Handy
Witchol IP-3000PT IP-Cam network camera let you monitor your surveillance system remotely anywhere around the world. It's a mini PC that comes with a camera where you can say "NO" to invest another PC specifically for surveillance purpose, uncomplicated installation and training, and yet with unlimited expansion, all you need is just a power and network cable and it's all DIY. Having achieved the professional level for security and surveillance
Supports Dynamic IP And Various Network Mode
Just switch on the power supply for the Witchol IP-3000PT IP-Cam, and it's all ready for action regardless whatever your network configuration may be, be it Static IP, DHCP auto acquire or PPPoE auto dial-connect and UPNP etc. network setting, it's all in the IP-3000PT IP-Cam, with the built-in PPPoE dial-connect program and DDNS server, it eliminate the trouble of keying of passwords every now and then. When the IP-3000PT IP-Cam power is switched on, it will send the current acquired IP address to you by e-mail or auto update to the Xenon IP-Cam server and it will be ready for monitoring anytime anywhere.
Unique Dynamic IP DDNS Server
To cater to the dynamic IP and ADSL dial-up subscriber, Xenon have setup DDNS server, Motion DNS server and IP Cam server, user no longer need a static IP and the tedious DNS application procedure, just key in the user name and the serial number, you camera IP address will auto communicate with the server thus solving your dynamic IP problem.
Internet and Intranet, Hassle Free Expansion And Easy Installation
Having the UPnP auto detect setting IP function, setting up of the IP-3000PT IP- Cam is even easier. Regardless of LAN or ADSL, wired version, simply install wherever the wire may run. There is no limit to the expansion, no more having to purchase another PC due to the lack of PCI slot, and just simply connect the Xenon IP-3000PT IP-Cam to the network with no setting required and you are ready for user friendly remote surveillance.
Diversify Surveillance; Centralize Management "Zero" Training
IP-3000PT IP-Cam is a mini PC, camera and surveillance system all-in-one; you no longer need to spend lots of money to purchase DVR card for the PC. With the advantage of diversifying surveillance and centralize management function, the IP-3000PT IP-Cam will not cause the whole security system breakdown due to malfunction of PC. No specific hardware requirement and no extra installation software, doing away with complicated operating system, the installation and setting of surveillance software and time for acquiring the relevant knowledge and worry about the stability of the system. This will reduce the maintenance cost substantially.
Up to VGA (640 X 480) Resolution
IP-3000PT IP-Cam provide the resolution of 640 X 480 with video recording and still image capture, synchronized camera audio and video recording, brightness, contrast and image quality adjustment etc. where it's all the perfect function for a surveillance system.
Audio and Video Recording Function
With the highly sensitive built-in microphone, IP-3000PT IP-Cam provide you with the recording of audio and video function, unlike those in the market where you can only record video without the audio.
IP-Cam DVR Software
IP-Cam DVR are mainly Windows based DVR software for building multi- channel video and audio surveillance DVR. IP-Cam DVR software ranges from entry level Xenon IC300 IP-cam to the flagship Witchol IP-3000PT IP- Cam full series products support. Up to 16 cameras can be connected and view live on a local monitor screen or thru TCP/IP Internet . Video can be recorded basing on specifiable schedules or motion detection. You can store video clips in HDD.
Online Firmware Upgrade
IP-3000PT IP-Cam is a human operated interface, all the functions can be controlled via the internet in real time and we provide online firmware upgrade function. No worries for future upgrading and continuity developing the IP-3000PT IP-Cam, as you have the most comprehensive security system
Features:
Built-in Motor for camera pan tilt
Remote access alert image review
Real-Time Motion Detection
Support TCP/IP, SMTP, FTP, PPPoE, UDP, UPnP, DHCP, (Dynamic Host Configuration Protocol)
Built-in web server allows camera to be accessed by standard Internet browser
Network RJ45: 10Base-T/100Base-TX Ethernet networks
Network ready, IP addressable (no PC is required.)
Motion-JPEG based compression
3 different resolutions: 640x480, 320x240, 160x120
Record AVI (video and audio) or Motion JPEG images on to hard disk for future viewing
Specification (System):
Stand-alone network camera for flexible installation
Simple installation and multiple mounting methods
Embedded Web Server Supported
No computer needed at the monitored site
Access live video web browser any time, any place for remote surveillance and management
2 default HTTP Ports supported. They can be changed to fit different network environment
Built-in Motion Detection for security with no extra cost
Standard JPEG Image Format
Record AVI or Motion JPEG images to hard disk for future viewing
Capture photos to your PC
Password protection, Supervisor password system for you to decide who is authorized to browse the camera, for E-mail and FTP alert
E-Mail the Detected images to preset FTP Server
Direct connecting to ADSL by PPPoE, mail the IP setting to pre-set mail address
3 selectable image resolutions and 3 image quality settings
2 selectable frequency: 50Hz and 60Hz
Unlimited number of users concurrently browsing the same camera
E-Mail notification for sharing or notifying information actively to the connected party
Camera ID name configuration
OSD for Camera ID and Date/Time
Web-based configuration interface
LAN/WLAN interface supported
Support Fixed IP or Dynamic IP by DHCP (Dynamic Host Configuration Protocol)
DDNS Server support
IP forwarding Server support
Remote reboot
On line Firmware update
Support PoE function, No need power adapter (Power Over Ethernet)
Support Power Adapter
Hardware reset button
Specification (Camera)
Sensor resolution: 640 x 480 pixel
Sensor type: Color CMOS Sensor
Minimum illumination: 3 Lux
Lens: F1.8, f 6.0m m , 58 degree View angle , Board Lens
Specification (Video)
Compressing Rate: 3 levels, low / middle / high
Motion-Jpeg Compression
Support Outdoor and Indoor NTSC and PAL system ( 50Hz / 60Hz)
5 mode resolution 160x120 / 176x144 / 352x288 / 320x240 / 640x480 and 3 level video quality
Frame Rate: 1 to 30
Brightness Control: Auto
Up and Down reversal: Yes
Mirror: Yes
320x240 @ 30 FPS, 640 x 480 @ 20 FPS (local lan) , video and audio
Specification (Audio)
Audio format: PCM, ADPCM
Built-in Microphone
Internal Microphone (mono) : Sensitivity: S/N 96db in 44.1kHz
Sampling Rate: 16kbps
Specification (Network)
LAN/WAN Support
Support Fixed IP or Dynamic IP by DHCP (Dynamic Host Configuration Protocol)
HTTP Ports supported. They can be changed to fit different network environment
DDNS Server support ,
IP port number mapping
Remote reboot
Support TCP/IP, HTTP, UDP, SMTP, FTP, PPPoE, UPnP, DHCP (Dynamic Host Configuration Protocol)
Support NTP Server
Specification (Camera Record and Alert)
Record AVI or Motion JPEG images on to remote PC hard disk for future viewing
Built-in Motion Detection for security with no extra cost
E-Mail the Detected images to preset FTP Server
Motion-Detection area setting
Password protection, Supervisor password system for you to decide who is authorized to browse the camera, for E-mail and FTP alert
Support GPIO Event Trigger and Motion-Detection Event Trigger
Specification (Wireless LAN )
Support USB Wireless Dangle for IEEE802.11 b and g
Zydas USB Dangle
WiFi IEEE 802.11b/g
SSID (Network Name)
Wireless Channel
WEP Encryption: Disable/64 bit/ 128 bit
WEP Encryption Code
Specification (Camera Interface)
10Base-T/100Base-TX Ethernet networks, RJ-45 connector
GPIO Interface, (IN x 1 , OUT x 1 )
DC 5V Power-in DC Jack connector
Reset button
USB Connector for USB wireless Dangle (Wireless IEEE802.11b and g)
PoE Switch (Power Over Ethernet)
PoE Power work status LED
Camera Power LED
Specification (CMOS Sensor )
Pick up Device: 1/4" CMOS image sensor (OV sensor)
4 Glass LENS
Specification (Pan / Tilt)
Built-in stepping motor for Camera PAN / TILT
Pan and Tilt function
Camera LENS view angle: 58 degree
Camera Pan Degree ( Mechanic angle ): 300 degree (-165° ~ +165°)
Camera Tilt Degree ( Mechanic angle ): 120 degree (Down 30° ~ up 90°)
Camera P/T View angle: Pan 358 degree , TILT : 178 degree
Camera LENS view angle: 58 degree
Camera rotate total view angle: 330 degree + 55 degree = 385 degree
Remote Website Control for Camera Pan/Tilt
Remote Software Control for Camera Pan/Tilt (16 camera channels P/T)
Auto Pan and Auto Tilt functions
Position presetting : 6 point
P/T Control: Up ,Down ,Right ,Left, Up-Right ,Up-Left, Down-Right ,Down-Left, Center
Auto Scan: Pan Auto Scan , Tilt Auto Scan
Presetting Position Scan : 6 position auto scan
Pan / Tilt Speed : 300 degree / sec
Click-to-move on image
Specification (Power)
Power DC 5V 2A, switching type power supply
Power Over Ethernet (PoE) , IEEE 802.3af
Power consumption 6.5W (1300 mA x 5 V) ,maximum
Specification (LED)
Power LED Blue color
PoE (Power Over Ethernet) LED: Red
Link/Active LED : Orange & Green
Specification (Operating environment)
Operating temperature 5°C ~ 42°C
Storage temperature -25°C ~ 52°C
Humidity 5% ~ 95% non-condensing
Specification (DVR Software )
Multi-Channels IP-CAM DVR software (16 Channels)
Motion-Detect Record / Schedule Record
Video and Audio Record
Accessories Include :
Witchol IP Cam IP-3000PT network camera
Power Adapter
Cross network cable (red) for connection to PC Network card for product testing
and setting
Straight network cable (blue) for connecting to Network Switches, ADSL Router
Installation CD Instruction manual
Warranty card
PoE (Power Over Ethernet) Adapter (Option)
Wireless IEEE802.11bg Dangle with external connector cable (Option)
Bundle Software:
Free-Bundled 16-CH Audio/Video Recording Software IP Edit
EMI & Safety: .
|
|
|
|
